Finned coils:

Built using copper tubes with a 1/2” diameter accor­ding to CUPROCLIMA® specifications, with aluminum corruga­ted fins. High performance rates can be achieved with these coils.

Fin spacing is 4 mm in the IRP series, 7 mm in the ICP series and 10 mm in the IFP series.

Every coil has passed a leakage test under a rated pressure of 3,923 kPa (40 kg/cm2) and pressurized using nitrogen at 147 kPa (1.5 kg/cm2) in order to avoid the co­rrosion of the inner surface of the copper tubes.

Casework:

The metal casing of the unit is manufactured in galvanized steel. Its external surface has an epoxy-polyester finish and is then baked and cured at 180°C, providing a high resistance to corrosion, even under extreme environmental conditions. Unfinished casing with a 450 mm diameter (Mg – Al).

The drip trays and side panels are easy to disassemble from the casework, providing easy and quick access to the inside of the unit.

Fans and motors:

Fans have a 450mm, 630mm or 800mm diameter (depending on the model) and feature three-phase motors (230 V / 400V @ 50-60 Hz).

Electric defrosting:

They are shielded with a stainless steel tube and their terminals are vulcanized over it to avoid electric shunts; every heater includes a single ground wire.

They are strategically located across the finned coil in order to achieve suitable and uni­form defrosting.

Electric heaters are included in the CC series and are optional in the CR series.